C .
Set the curved
glass inside the
gutter on the lip
that is sticking out .
When you set the
curved glass on the
gutter
5
, push
the glass towards
the aluminum
frame . The frame
should be square,
if not, go to the
base or ridge and
push it over to
make it square to the glass . When putting on the cap on the end bars, be sure that you have
put two / three rows of foam on the outer edge of the end bar . otherwise, the aluminum
cap will be twisted crooked
6
. Work carefully as the curved glass does not have as much
bending tolerance as flat glass . When you fasten on the curved aluminum cap, do not screw it
too tightly . You do not want to put too much pressure on the glass . When an aluminum glass
bar is bent, the tempering of the aluminum may vary somewhat and the glass bar may not be
exactly
the same radius as the glass . Therefore, you need to take extra care when you install the
curved pieces . If the glass does not fit solidly onto the foam rubber, just lift the glass off, put
on a second row of foam (usually in the middle of the curve) and reinstall the glass .
– 24 –
p r i d e o f t h e p a c i f i c S e r i e S c U r V e d G L a S S L e a N t o M o d e L • G r e e N h o U S e i N S t r U c t i o N S
C
5
6
