p r i d e o f t h e p a c i f i c S e r i e S c U r V e d G L a S S L e a N t o M o d e L • G r e e N h o U S e i N S t r U c t i o N S
– 27 –
(Refer to the drawing on next page.)
Take the door and set it inside the doorframe . Lift it up as high as
possible on the hinge side and put the screws through the existing holes in the doorframe .
Now the
door will hang by itself.
remove the plastic clip from the “z” bar and put one screw into the doorframe to hold the “z”
bar . open the door, take off the clips and put back the screws . Close the door and check that it is
square . If the frame and the door are square,
then fasten the “z” bar to the frame . If not,
move the “z” bar up or down to square it . If
this is not enough, loosen the bolts in the top
plates and move the frame to make it square .
When it is in place, tighten all the bolts .
next install the door handle (see the
instructions inside the box) . To install the
door catch angle, slide in two bolts into the
back of the door frame . Bolt on a small angle
(provided with the door handle) . Face the angle
towards the door, line it up with the center of the door handle, and then tighten the two bolts
(see
picture to the right)
. Take the door catch out of the door handle box and screw it on . Close the door
and adjust the door sweep at the bottom of the door to eliminate potential gaps .
NOTE:
There are two types of manufactured doors. The door catch angle on the white door may have to be
turned the opposite way as shown on picture
1
.
run a bead of silicone under the angle above the door and against the doorframe . Also
silicone the “ ” on the glass beside the door to ensure an airtight seal .
Z Bar
Z Bar
Door Installation
1
Door Catch Angle
