Assembly of Aluminum Frame
A . BACK GABLe enD ASSeMBLY
Lay out the back pieces into the shape of the end wall .
Refer to the line/detail drawing.
1 .
For the curved glass end bars, the flat surface should lie on the ground
(See the example to the right. Use the curved end bar with an angle cleat attached to the side).
2 .
Bolt the Glass Bars on the top first
(See Detail #1 & 1A, Page 8).
3 .
Bolt the base/sill to the bottom of the Glass Bars
(See Detail #2, Page 8).
4 .
The angle brace is bolted approximately 56” from the base . The slider brackets that have
already been fastened to the poly end bar curve will determine the height
(See Detail #3, Page
8).
When bolting the horizontal cross brace onto the back wall, measure the back wall so that
it does not sag
(See Detail #4, Page 8).
– 7 –
Back Gable End Line Drawing Assembly Procedure
Curved Glass end Bars
Glass Bars
1” x 2” Angle Base
Cross
Brace
p r i d e o f t h e p a c i f i c S e r i e S c U r V e d G L a S S L e a N t o M o d e L • G r e e N h o U S e i N S t r U c t i o N S
GROUND
1
2
3
4
