Greenlee Textron / Subsidiary of Textron Inc.
17
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Bus Bar Punch System
Key
Part No.
Description
Qty
30
503 8153.9
Busbar Alignment Plate ............ 1
31
503 8534.8
Scale Pointer ............................ 1
32
905 2760.7
Drive Screw .............................. 2
33
905 4275.4
Adjustable Handle .................... 1
34
905 4193.6
M6 Button-Head Screw ............ 2
35
503 9020.1
Punch Alignment Guide ........... 1
36
503 9022.8
Alignment Top Plate ................. 1
37
503 7742.6
Decal ........................................ 1
38
503 7325.0
Clamping Strip .......................... 1
39
905 3448.4
#10 Shoulder Screw ................. 2
5.
Attach the assembled alignment table to the bus bar
punch yoke (X) with four button-head screws (V) as
shown in the exploded view.
6.
Place any die in the die holder (T).
7.
Adjust the alignment table so that the table top is
level, and at the same height as the top of the die.
8.
Tighten the four button-head screws (V).
Assembly
1.
Place the punch alignment guide (35) on the
alignment top plate (36). Thread, but do not tighten,
the two button-head screws (34) through the end
slots of the guide and into the top plate (36).
2.
Place the alignment top plate (36) on top of the bus
bar alignment plate (30). Insert the adjustable
handle (33) through the middle slot of the punch
alignment guide, through the alignment top plate,
and through the bus bar alignment plate; thread the
handle into the clamping strip (38).
3.
Apply a drop of Loctite
®
242 or equivalent on the
threads of the shoulder bolt (39). Insert the shoulder
bolt through the clamping strip (38) and into the bus
bar alignment plate (30). Thread the shoulder bolt
into the hole in the alignment top plate.
4.
Attach the scale pointer (31) to the bus bar align-
ment plate (30) with the two drive screws (32).
Alignment Table (Standard) (503 9021.0)
36
35
34
33
32
31
38
39
30
37
