C3 Auto Whip Clad Cable Cutter
Greenlee Tools, Inc.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
31
Feed Roller Replacement
The urethane rubber feed roller will wear and should be replaced.
1. Remove the Chip Tray and empty. Also, use a vacuum to remove any remaining chips of aluminum, steel,
copper, and insulation from the cabinet.
2. Lay the entire machine on its back by rotating it 90 degrees.
3. Remove (6) 8-32 X .625" button head cap screws which secure the expanded steel Access Panel just above the
Chip Tray on the bottom of the machine.
4. Remove the Access Panel.
5. Open the Acrylic Door and locate the Urethane Rubber Drive Wheel. In front of the roller and behind the roller are
a Pillow Block Bearing Unit and the servo motor assembly.
6. Remove (2) 5/16-18 X ½" socket head cap screws securing the pillow block and slide the pillow block off of the
motor shaft Extension.
7. Remove (4) 5/16-18 X ½" socket head cap screws securing the servo motor assembly.
8. The servo motor and roller assembly can now be lowered thru the chip tray access opening.
9. Loosen (2) set screws securing the roller to the shaft.
10. Slide the Drive Wheel off of the shaft.
11. Position the new 52082254 Drive Wheel with the teeth oriented as show below and install by repeating steps 10
thru 1 above.
Service
(con’t)
A
Wheel
Rotation
A
Loosen (2) Set Screws
& Remove
Remove (2)
Screws & Pillow
Block
Remove (4) Screws
& Lower Servo Motor
Remove
Expanded Steel
Access Cover
Remove (6)
Screws
Enlarged View
