11147 Ultra Tugger
®
Adapter Package
Greenlee Tools, Inc.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
10
Setup
(cont’d)
Mounting Components
(cont’d)
Slip-in Coupler
Requires: One pin to connect to Nose Unit
1. Select the coupler that best fits the conduit.
2. Slide the coupler into the conduit until the coupler
seats on the end of the conduit.
Note: If the coupler does not seat on the conduit,
see “Straddling the Conduit with a Slip-In Coupler.”
Pull
Conduit
Coupler
Coupler must seat
on the Conduit here
3. Slide the nose unit over the coupler. Align any set of
holes and insert one pin. Secure the pin with a hitch
pin clip.
Note: If possible, add a second pin and hitch pin
clip.
Nose Unit
Coupler
Pin secured with
Hitch Pin Clip
Straddling the Conduit with Slip-in Coupler
Requires: Two pins to connect to Nose Unit
1. Select a coupler at least 25 mm (1") larger than the
conduit.
2. Place the coupler over the conduit.
Note: Do not use this method if the coupler does not
seat on a support structure that can support 35.6 kN
(8000 lb) of force.
Pull
Conduit
Coupler
Conduit must
not protrude
past here
Support
Structure
3. Slide the nose unit over the coupler. Align any two
sets of holes and insert two pins. Secure the pins
with hitch pin clips.
Pull Conduit
Coupler
Conduit must not
protrude past here
Support
Structure
