INSTALLATION GUIDE – WARNING
INSTALLATION INSTRUCTIONS:
1. Turn power off
4. Turn on power on.
2. Remove lens or diffuser if applicable. Remove existing fluorescent lamp(s)
from luminaire. Note: Verify that the fluorescent tube type is listed on the
LED lamp label.
3. Install LED lamp (one for each fluorescent lamp removed, ensure pins are
firmly seated in lampholders). Place Lens or diffuser back in place if applicable.
OFF
ON
Model NO: 14.5W/T8/4A/35K or 14.5W/T8/4A/40K
LIMITED WARRANTY:
This product is warranted to be free from defects in workmanship and material for 5 years. If it fails to do so,
Greenlite™ will send you, at its election, a replacement product or refund your original purchase price upon
receipt of the returned fixture, register receipt and proof of purchase. Please call
(844) 695-9090
to find out
how to return the product. Do not return this product to the retailer. This limited warranty does not cover product
subject to accident, neglect, abuse, misuse or acts of God. Replacement or refund is your sole remedy.
For all enquiries, please contact our customer service team at
info
@
greenliteusa.com
or
1-844-695-9090
from 9:00 AM to 5:00 PM EST.
www.greenliteusa.com
V1-11/01/2021
14.5W LED T8 Linear Tube
Ballast Compatible - Type A or Plug & Play
• DANGER
: Risk of shock-disconnect power before installation.
•
WARNING:
Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaire electrical systems. If not qualified,
do not attempt installation. Contact a qualified electrician.
•
WARNING:
Product must be installed in accordance with the national electrical code or your local electrical code. If you are not familiar
with these codes and requirements, contact a qualified electrician.
•
WARNING
: Install this kit only in luminaries that have the construction features and dimensions shown in the photographs and/or drawing
and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
•
WARNING
: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. Do not make or
alter any open holes in any enclosure of wiring or electrical components during kit installation.
•
WARNING
: This lamp only operates on electronic ballasts.
• Do not use with dimmers
• Suitable for dry and damp locations.
• This device is not intended for use with emergency exits.
• This device complies with part 15 of the FCC rules
CAUTION
- IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING, FLICKERING, ETC.), IMMEDIATELY TURN OFF
POWER, REMOVE LAMP FROM LUMINAIRE AND CONTACT THE MANUFACTURER.
