Greentec HS172-212-242 Cutterbar
31
Preparing a new knife for
mouning
►
Loosen the nuts on the three
sections on which the knife
head is to be mounted.
►
Loosen the nuts on both
sides of the next section.
►
Tap the serrated stud bolts
to remove them.
►
Remove the three sections.
►
Loosen the two outer bolts on
the knife connection of the
old
knife.
►
Remove the knife
connection.
►
Mount the knife connection
on the
new
knife.
►
Make sure that the
protrusions of the press-in nuts
point upward and are seated
properly during assembly.
►
Tighten the two bolts to the
specified tightening torque.