Greentec HS172-212-242 Cutterbar
36
Attach first guard V/O
►
Position the first guard V/O
below the profile bar.
►
Insert the bolts.
►
Tighten the nuts to the
specified tightening torque
Replace the safety finger
If the position of the safety finger on the guard is not correct, it can be aligned to
correct this. Damaged safety fingers must be replaced immediately.
Remove the safety finger
►
Unscrew the nut on the safety
finger and remove the bolt.
►
Remove the safety finger from
the profile bar.
Mount the safety finger
►
Position the safety finger
beneath the profile bar.
►
Insert the bolt and tighten the
nut to the specified tightening
torque.