GreenTech Pureheat 2-in-1, Owner'S Manual

7

UNIT SETUP

1 . 

Unpack the unit by cutting open taped areas. Fold back box flaps and gently 
turn entire box upside down . Lift box off of styrofoam packed contents . Remove 
styrofoam, turn upright . We recommend keeping packing materials for future 
transport or storage of unit .

2 . 

Find a level and unobstructed location to place heater away from cold walls 
(outside walls).

3 . 

Plug the POWER CORD into a grounded outlet (120V, 15A or higher).

4 . 

Activate the REMOTE by removing the plastic shipping guard from the battery 
compartment .

INSPECT THE PUREHEAT 2-IN-1 FOR DAMAGE BEFORE SETUP OR USE.

USING PUREHEAT 2-IN-1

READ ALL WARNINGS & CAUTIONS (PAGE 4) BEFORE USING YOUR PUREHEAT 2-IN-1.

Turning the Unit On/Off

• 

Turn the unit on by pressing the “I” on the POWER TOGGLE (Unit Rear).

• 

Turn the unit off by pressing the “O” on the POWER TOGGLE (Unit Rear).

• 

Always unplug the unit when not in use .

Heater Mode

• 

Press the HEATER CONTROL button to activate the Heater Mode . (This will also 
automatically activate Purifier Mode. To toggle Purifier Mode on or off, press the 
PURIFIER CONTROL button.)  Set the desired temperature using the TEMPERATURE 
CONTROL buttons . You may select a temperature from 60 to 90 degrees Fahrenheit .

Purifier Mode

• 

Toggle the Purifier Mode on or off at any time that the unit is turned on by pressing 
the PURIFIER CONTROL button .