8
USING PUREHEAT 2-IN-1 (continued)
Standby Mode
•
When the room exceeds set temperature by 2 Degrees F the heater goes into
“STANDBY MODE”, essentially turning off except the temperature sensor . After that,
when the room drops 2 Degrees F below the set temperature, the heater comes
back to normal operation . This is because the heater radiates a small amount of
heat even when the fan is on the lowest setting, which would cause the heater
to continue raising the temperature of a small room indefinitely were it not for the
“STANDBY MODE” feature .
Timer Function
•
Set the TIMER FUNCTION by pressing the TIMER CONTROL button to activate it .
•
Press the TIMER CONTROL button once for each additional hour desired (1 - 12 hours).
•
If you press the TIMER CONTROL button again once the TIMER INDICATOR on the LCD
DISPLAY reads “12h” the TIMER FUNCTION will be deactivated .
•
If the Heater & Purifier Modes are active and you set the timer, it will turn both modes
off after the designated time has elapsed .
•
If either the Heater or Purifier Modes are independently active and you set the timer,
it will turn the active mode off after the designated time has elapsed .
•
If neither the Heater or Purifier Modes are active (nothing is active) and you set the timer,
it will turn ON both the Heater and Purifier Modes after the designated time has elapsed.
Quiet Function
•
If you feel the unit is too loud for your environment, such as when you are sleeping,
press the QUIET MODE CONTROL button . The unit continues to heat, humidify, and
purify according to active modes, but the fan runs on the most silent speed .
Audible Notifications
•
When the heater reaches the set temperature it will produce an audible tone to let
the customer know . It will produce the same tone when it goes into “STANDBY MODE” .
Summary of Contents for Pureheat 2-in-1
Page 1: ...Owner s Manual...
Page 12: ...12 www GreenTechEnv com...
