GreenTech Pureheat 2-in-1, Owner'S Manual

9

MAINTENANCE 

DISCONNECT PUREHEAT 2-IN-1 FROM THE OUTLET BEFORE ANY MAINTENANCE OR CLEANING.

Replacing the PCO Cell

After some time the “Replace UV BULB” indicator may appear on your LCD SCREEN . 
This indicates that you need to replace your PCO Cell . You may purchase a 
replacement PCO Cell through your GreenTech Environmental Authorized Distributor . 
If your distributor is not available, please visit www .GreenTechEnv .com to contact us 
regarding ordering a PCO Cell directly . 

1 . 

Remove the FILTER ASSEMBLY by following steps 1 through 3 of “Cleaning the Filter” .

2 . 

Unplug the old PCO Cell by squeezing and disengaging the electrical adapter in the 
lower right hand region of the rear of the unit .

3 . 

Unscrew both of the plastic coated brass thumbscrews from their posts . Set the 
thumbscrews aside where you will not misplace them .

4 . 

Slide the old PCO Cell straight out of the rear of the unit .

5 . 

Slide the new PCO Cell straight into it’s place in the rear of the unit .

6 . 

Screw both thumbscrews back onto their post until snug .

7 . 

Connect the new PCO Cell by plugging in the electrical adapter to it’s socket until  
it clicks into place .

8 . 

Replace the FILTER ASSEMBLY by following steps 7 through 9 of “Cleaning the Filter” .