70
Connected Lighting
2. On the
Gateway
, press the sync button once. The activity indicator begins to display
a clockwise rotating pattern.
3. On the
remote control
, press and hold the
Program
button.
4. While pressing the
Program
button, press the
1-4
button
three times
consecutively.
5. Release the
Program
button. The primary indicator light on the remote control flashes while the
remote control connects with the Gateway. When this process is complete, the indicator light will
remain on for approximately five seconds. When the indicator light turns off, your remote control is
connected to the Gateway.
6. Press the sync button on the Gateway again to stop the network search process (otherwise the
Gateway will stop the search process automatically in five minutes).
Turning Lights on and Off
To turn lights on and off, you must turn on and off an entire lighting group:
1. Press the
Group Number
button for the lighting group you want to turn on or off. If you want to turn
on or off
ALL
lighting groups, press the 1-4 button.
2. Press the
On/Off
button. If the lights were previously off, they will turn on. If the lights were
previously on, they will turn off.
Note: The previously selected group (or all groups, if selected) remains the active group on the remote control.
To take action on that same group again, you do not have to press the group button again.
Brightening and Dimming Lights
You can brighten and dim your lights even if they are not connected to a fixture with a dimmer switch. CFL light
bulbs, which typically do not brighten or dim, can also brighten and dim on your network. To set the brightness
level of lights, you must set the level for an entire lighting group:
1. Press the
Group Number
button for the lighting group you want to dim or brighten. If you want to
dim or brighten
ALL
lighting groups, press the 1-4 button.
2. To dim the lights in the selected group(s), press and hold the dimmer button. Release the button
when the lights reach the level you want.
3. To brighten the lights in the selected group(s), press and hold \ the dimmer. Release the button
when the lights reach the level you want. They automatically stop when they reach full brightness.
The lights in the group will remember the latest brightness level when you turn them off and on.
Summary of Contents for GL30000
Page 1: ...Connected Lighting...
