72
Connected Lighting
Note: The previously selected group (or all groups, if selected) remains the active group on the remote control.
To take action on that same group again, you do not have to press the group button again.
Assigning and Changing a Light Bulb’s Lighting Group
Note: This section describes managing lighting groups through your remote control. It is easier to set up your
lighting groups using your smart device or Web browser and then only use your remote control for turning on
and off your lighting groups.
You can assign or change the lighting group to which a light bulb belongs, and you can change multiple light
bulbs so that they all belong to the same lighting group. To change a light bulb’s lighting group, you must first
remove the bulb from the network using the removal procedure in this chapter. After the light bulb is removed,
you can use the procedure in this chapter for adding the light bulb to the network and assign it to the new
lighting group.
Replacing Batteries
Your remote control uses two AA 1.5V alkaline batteries (included). To replace the batteries, remove the battery
cover from the back of the remote control and remove the old batteries. Insert the new batteries as indicated in
the battery compartment.
Resetting the Remote Control
You can reset the remote control back to the original default settings from the factory. Typically, though, factory
reset is not a common procedure and you should be certain you want to do so since you will lose any network
settings you previously programmed onto the remote control. If you are sure you want to reset the remote
control, use the following steps:
1. Remove the battery cover from the back of the remote control.
2. Remove the batteries from the remote control.
3. Press and hold the
Program
button.
4. While still pressing the
Program
button, reinsert the batteries into the remote control.
5. Continue pressing the
Program
button for two seconds, until all indicator lights on the remote
control turn on.
6. Release the
Program
button.
The remote control is returned to its default factory settings. To use it again, you must follow the original
installation instructions.
Summary of Contents for GL30000
Page 1: ...Connected Lighting...
