3. Push and hold the battery release button (24).
4. Remove the battery pack (25) from the machine.
8
OPERATION
WARNING
Wear eye protection during operation.
8.1
START THE MACHINE
1. Push and hold the start button (1).
2. While you hold the start button (1), pull the bail
switch (4) in the direction of the handle bar.
3. Once the machine has started you can release the
start button (1).
8.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
WARNING
Always remove the battery pack after you complete
the work.
8.3
OPERATE THE SELF-PROPEL
SYSTEM
NOTE
The machine is built with a thermal protector to stop
the self-propelled motor when overload occurs. It’s a
device calibrated to open the self-propelled motor
circuit upon reaching a certain temperature/current.
Re-setting the protector requires both cool down
below the calibration point and removal of power
supply. When the protection happens, the operator
should release the self-propel bail lever (5)
immediately ,then restart the mower after at least 30
minutes.
1. Start the machine.
2. While you hold the bail switch (4), push the self-
propel lever (5) in the direction of the handle bar.
3. Hold the bail switch (4) and the self-propel lever (5)
at the same time with your right hand.
4. Adjust the speed control button (6) with your left
hand.
• Push the speed control button in the direction of
the Rabbit Symbol to increase the speed.
• Pull the speed control button in the direction of
the Turtle Symbol to decrease the speed.
5. Release the self-propel lever (5) to close the self-
propel system.
8.4
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the battery pack.
3. Open the rear discharge door and hold it.
4. Hold the grass catcher by its handle and unhook it
from the door rod.
5. Close the rear discharge door.
6. Empty the grass catcher.
8
English
EN
