34
P0803466-00 v.2.0
MAINTENANCE
BATTERY MAINTENANCE
W A R N I N G
When servicing, use only identical Greenworks replacement parts. Use of any other parts may create a
hazard or cause product damage.
W A R N I N G
It is not recommended to use compressed dry air as cleaning method of the charger. If cleaning with
compressed air is the only method available, always wear safety goggles or safety glasses with side
shields. If the environment is dusty, also wear a dust mask.
Your Greenworks mower is powered by a lithium module which, when maintained properly, will provide
years of useful life. For proper care, adhere to the following instructions:
• Always charge batteries after each use, regardless of how little used. Batteries must be attached to a
plugged-in battery charger with the charger power switch “ON” when the unit is not being used.
W A R N I N G
Charge only with a Greenworks approved charger. Do not use battery chargers other than those
recommended by Greenworks Equipment. Incorrect battery charging will void warranty and can lead to
equipment damage, serious injury or death.
• Check that battery cables are securely tightened to batteries each time you service the battery.
• Keep grass, dirt and debris from collecting near battery terminals.
• Batteries are not to remain in a discharged state or damage to the batteries will occur.
•
Charge batteries indoors in a well-ventilated and dry location away from sparks or flames. Never
expose charger to rain, vapor or liquid.
• Charge only lithium batteries provided by Greenworks.
• Do not touch uninsulated portion of charger (terminal pins) or of output connector.
• Do not use with defective cords and wires. Replace defective cords and wires immediately.
SERVICE
• Park the mower on level ground. Make sure that steering control levers are in the neutral position, and
that the deck blade switch is in “OFF” position. Raise deck, rotate key to “OFF” position, remove key
from switch and disconnect battery cables by pulling inward on RED battery quick disconnect handle in
battery box compartment.
I M P O R T A N T
Wait for all movement to stop before adjusting, cleaning or repairing. Repairs or maintenance requiring
power should be performed by trained maintenance personnel only. Read and observe safety warnings in
front of manual.
• Any maintenance operation that requires the removal of safety covers must be performed by a trained
service technician.
• Before working on or under the deck, make certain master power ignition switch is “OFF” and key is
removed and deck blade switch cannot be accidentally started and disconnect battery cables by pulling
inward on RED battery quick disconnect handle in battery box compartment.
I M P O R T A N T
Repairs or maintenance requiring power should be performed by trained maintenance personnel only.
