If there is too much pump pressure, the spray tip can become
clogged, you can feel a pulsing sensation while you pull the
spray gun trigger.
5.1.1
REMOVE THE SPRAY TIP
1. Pull back the quick-connect collar (29) on the spray wand
(5).
2. Remove the spray tip (28) from the spray wand (5).
5.1.2
CLEAN THE SPRAY TIP
1. Use a straight paper clip or cleaning tool (14) to clean the
spray tip.
2. Flush and clean the unwanted materials out of the spray
tip (28) with the garden hose (25).
3. Install the clean spray tip (28) to the spray wand (5).
6
TRANSPORTATION AND
STORAGE
WARNING
Disconnect the power cord and watter supply hose before
transportation and storage.
6.1
MOVE THE MACHINE
•
Point the spray wand in a safe direction.
•
Only hold the machine with the handgrip.
6.2
STORE THE MACHINE
WARNING
Make sure that the spray gun, the uberflex hose and the
pump are dry.
WARNING
Make sure the machine is out of the reach of children.
NOTE
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
•
Disconnect the garden hose from machine.
•
Wind the power cord and the uberflex hose.
•
Clean housing and the plastic components with a moist
and soft cloth.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
If needed, call the customer service phone number
(enter number here) for servicing instructions.
•
Store the machine in a dry, isolated and frost-free area.
7
TROUBLESHOOTING
PROBLEM
POSSIBLE
CAUSE
SOLUTION
The motor does
not start.
The power button
is in the "OFF"
(O) position.
Set the power
switch to the
“ON” ( | ) posi-
tion.
The power cord is
not plugged in.
Connect the power
cord to the power
supply.
Electrical outlet
does not supply
sufficient power.
Try another elec-
trical outlet.
The circuit breaker
is tripped.
Let it cool, and
start the machine
again.
The power switch
is on, but you do
not pull the spray
gun trigger.
Pull the spray gun
trigger.
The machine does
not reach high
pressure.
The diameter of
garden hose is too
small.
Replace with a 1”
(25 mm) or 5/8”
(16 mm) garden
hose.
Water supply is re-
stricted.
Check garden hose
for kinks, leaks,
and blockage.
The water supply
is not sufficient.
Open the water
supply fully.
Spray tip has not
be installed onto
the spray wand
properly.
Install desired
spray tip to end of
wand.
The water intake
filter is clogged.
Remove filter and
rinse in warm wa-
ter.
10
English
EN
