a
b
c
d
e
4. Clean dirt and debris from all parts. Replace spool (d) if it
is worn or damaged.
5. Align the spool tabs (a) with the tab openings in the base
of the spool (e).
6. Push the spool cover until it clicks into position.
10.4 INSTALL THE CUTTING LINE
NOTE
Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
10.5 REMOVE THE TRIMMER HEAD
1. Put the metal rod (a) in the specified angle transmission
hole (b) to fix the trimmer head.
11
English
EN
