Line exit hole
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
10.4 REPLACE THE CUTTING LINE
NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 0.065" (1.65
mm) diameter.
1. Cut two pieces of cutting line approximately 3m long
of each.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Put the lines into the anchor holes of the spool.
4. Wind the cutting lines around the spool tightly in the
indicated direction.
5. Put the cutting lines in the guide slots.
6. Do not wind the cutting line beyond the edge of the
spool.
11
TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
tranportation and storage.
11.1 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
12
TROUBLESHOOTING
Problem
Possible Cause
Solution
The ma-
chine does
not start
when you
push the
trigger.
No electrical
contact between
the machine and
the battery pack.
1. Remove battery
pack.
2. Check contact and
install the battery pack
again.
The battery pack
is depleted.
Charge the battery
pack.
The lock-out but-
ton and trigger
are not pushed
at the same
time.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to
start the machine.
11
English
EN
