11
ASSEMBLY INSTRUCTION
BATTERY
IMPORTANT!
The battery pack (2901302 Rated 80VDC,144WH) is not charged when it is
purchased. Before using the hedger for the first time, place the battery pack on the battery charger
and charge. Make sure to read all safety precautions, and follow the instructions in the Battery
Charger section.
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
•
Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
•
Verify that the switch is in the OFF position before inserting or removing the battery pack.
•
Verify that the battery pack is removed and the switch is in the OFF position before
inspecting, adjusting, or performing maintenance on any part of the hedger.
•
Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
To remove the battery
(See Figure 2.)
:
1. Press the latch button on the battery pack down (1) and hold.
2. Grasp the rear handle (2) firmly. Pull the battery pack out of the handle.
NOTE:
The battery pack snugly into the handle to prevent accidental dislodging. It may require
a strong pull to remove.
To install the battery
(See Figure 2.)
:
1. Align the tongue (3) of the battery pack with the cavity in the handle housing.
2. Grasp the rear handle (2)
3. Push the battery pack into the handle until the latch locks into place.
Fig. 2
IMPORTANT!
DO NOT remove the blade assembly unless it needs sharpening, straightening, or
replacing. Take it to a
person for repair.
1
3
2
