1
DESCRIPTION
1.1
PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2
OVERVIEW
Figure 1 - 11.
1
Turbo button
2
Cruise control lever
3
Trigger
4
Front blower tube
5
Hose clamp
6
Rear blower tube
7
Latch
8
Battery
compartment
9
Harness
10 Trigger handle
11 Flexible tube
2
SAFETY
WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3
INSTALLATION
3.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2
INSTALL THE TRIGGER HANDLE
Figure 2.
1. Move the trigger handle onto the rear blower tube.
2. Move the trigger handle to necessary location on the
rear blower tube.
3. Install and tighten the available short screw.
3.3
INSTALL THE REAR BLOWER
TUBE
Figure 3.
1. Put the hose clamp around the flexible tube.
2. Put the end of the rear blower tube into the flexible
tube at a small angle.
3. Push the end of the rear blower tube into the flexible
tube.
4. Install and tighten the available long screw into the
hose clamp.
WARNING
Put the cord in the cord retainer.
3.4
INSTALL THE FRONT BLOWER
TUBE
Figure 3.
1. Align the grooves on the front blower tube with the
tabs on the rear blower tube.
2. Install the front blower tube onto the rear blower
tube until the tabs engage the grooves.
3. Turn the front blower tube in the direction of the
arrow until the tabs lock into position.
3.5
INSTALL THE BATTERY PACK
Figure 4.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6
REMOVE THE BATTERY PACK
Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4
English
EN
