12
STARTING THE SNOW SHOVEL
W A R N I N G
Avoid accidental start-ups. Verify that the operator is in the starting position when using the snow
shovel. In order to avoid serious injury, the operator and unit must be in a stable position when
starting the Snow Shovel.
USING THE SWITCH
This Snow Shovel is equipped with a special safety switch. In order to operate the switch, insert
one finger into the opening, and push the lever out so that it can be grasped along with the upper
handle. Pull the lever back in order to turn the Snow Shovel on, and hold it against the upper
handle in order to keep it running. To turn the Snow Shovel off, simply release the lever.
C A U T I O N
Do no attempt to override the operation of this safety switch.
USING THE SNOW SHOVEL
• Start the Snow Shovel by following the Starting instructions. The depth and weight of the
snow will determine the forward speed.
• Push the Snow Shovel forward so that it rides on the scraper.
• Verify that the power cord is attached to the cord retainer and that it rests on the guide bar.
The power cord should trail to the side of the operator.
USING THE CORD RETAINER
(See Figure 4)
• Attach the outlet end of an extension cord to the plug on the rear of the snow thrower.
• Make a loop in the extension cord. From the right side, pass the loop through the hole in the
back of cord retainer and place it around the hook.
OPERATING INSTRUCTIONS
Fig. 4
Plug
Cord Retainer
Summary of Contents for 26022
Page 22: ...22 EXPLODED VIEW ...
Page 25: ...25 NOTES ...
