15
OPERATION
Setting O
Hard materials such as metals or thin sheet metais. This setting can be used
with knife blades, grit edge blades, rasp work, and down cutting blades.
Setting 1
Soft materials where cleaner cutting or delicate scrolling work is performed.
Setting 2
Medium density materials such as harder woods or particle board.
Setting 3
Soft materials such as wood, plastics, etc. and when fast cutting is more
important than a clean cut.
FOOTPLATE ANGLE ADJUSTMENT
The footplate may be tilted to allow angle cuts up to 45° in either direction. To adjust footplate,
loosen screw with alien wrench provided, slide the footplate slightly forward towards the front of
angles may be set with a protractor. After positioning the footplate securely tighten screw .
BLADE ORBIT SELECTOR LEVER
material being cut.
The following chart will help you determine which setting to use for your application. This chart
is intended as a guideline only, and test cuts in scrap material should be performed first to
determine the best setting.
0
1
2
3
0
1
2
3
0
1
2
3
0
1
2
3
FOOTPLATE
FOOTPLATE
screw
BEVEL
SCALE
'Intefmediate
°
Summary of Contents for 36102a
Page 20: ...20 EXPLODED VIEW...
