27
Problem
Cause
Solution
Trimmer head
will not advance
line.
1. The motor shaft or trimmer
head is bound with grass.
1. Stop the trimmer
,
remove the battery, and
clean the motor shaft and trimmer head.
2. There is not enough line on
the spool.
2. Remove the battery and replace the cutting
line
;
follow the section “line replacement”in this
manual.
3. The trimmer head is dirty
.
3. Remove the battery and clean the spool,
spool retainer and spool base.
4. The line is tangled on the
spool
.
4. Remove the battery, remove the line from
the spool and rewind
;
follow the section "line
replacement" in this manual.
5. The line is too short
.
5. Remove the battery and pull the lines while
alternately pressing down on and releasing
the bump knob.
6. Bump head hit on the grass. 6. Remove bump head hit on the ground.
Line keeps
breaking.
1. Trimmer used incorrectly.
1. Only trim with the tip of the line
,
avoid
stones
,
walls and other hard objects. Feed the
line regularly to maintain full cutting width.
Grass wraps
around trimmer
head and motor
housing.
1. Cutting tall grass at ground
level
1. Cut tall grass from the top down
,
removing
no more than 8 inches in each pass to prevent
wrapping.
Line is not
cutting well
1. The line-cutting blade on the
edge of the guard has become
dull
.
1. Sharpen the line-cutting blade with a file or
replace it with a new blade.
TROUBLESHOOTING
