12
BATTERY
IMPORTANT!
The battery pack (29462/29472) does not come fully charged. Before using the
battery pack, place the battery pack on the battery charger allowing for a 5 hour charge or follow
the in the battery charger instructions.
To install the battery
(See Figure 2.)
1. Align the tongue (3) of the battery pack with the cavity in the handle housing.
2. Grasp the rear handle (2) firmly.
3. Push the battery pack into the handle until the latch locks into place.
NOTE:
The battery pack fits snugly into the handle to prevent accidental dislodging. It may
require a strong pull to remove.
To remove the battery
(See Figure 2.)
1. Press the latch button (1) on the battery pack down and hold.
2. Grasp the rear handle (2) firmly. Pull the battery pack out of the handle.
IMPORTANT!
DO NOT remove the blade assembly unless it needs sharpening, straightening, or
replacing. Take it to a qualified person for repair.
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
ASSEMBLY INSTRUCTION
•
Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
•
Verify that the switch is in the Off position before inserting or removing the battery pack.
•
Verify that the battery pack is removed and the switch is in the Off position before
inspecting, adjusting, or performing maintenance on any part of the hedger.
•
Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
2
1
3
Fig. 2
Summary of Contents for HT40L00
Page 22: ...22 EXPLODED VIEW...
