24
Problem
Cause
Solution
Lines will not
advance.
1. Lines are welded to
themselves.
1. Lubricate with silicone spray. Respool the
head by following the directions in this manual.
2. Not enough line on
spool.
2. Install more line. Refer to Line
Replacement earlier in this manual.
3. Lines are worn too short
.
3. Pull line while pressing button.
4. Lines are tangled on
spool
.
4. Remove lines from spool and rewind.
Refer to Line Replacement earlier in
this manual.
Line keeps
breaking.
1. Trimmer used incorrectly.
1. Only trim with the tip of the line
,
avoid
stones
,
walls and other hard objects. Feed the
line regularly to maintain full cutting width.
Grass wraps
around trimmer
head and motor
housing.
1. Cutting tall grass at ground
level
1. Cut tall grass from the top down
,
removing
no more than 8 inches in each pass to prevent
wrapping.
Line is not
cutting well
1. The line-cutting blade on the
edge of the guard has become
dull
.
1. Sharpen the line-cutting blade with a file or
replace it with a new blade.
TROUBLESHOOTING
