Link-Belt MG-534 Calibration
22
W450160 10/07
Menu 05 – Main Boom Radius/Moment
IMPORTANT!
If ThIS IS NOT A PROTOTyPE CALIBRATION, ThEN ALL RADIuS/MOMENT DATA WILL BE
PRECALIBRATED AND COPIED OvER fOR uSE DuRINg CRANE DATA RESET. ThERE ShOuLD
BE NO NEED TO PERfORM ThIS ROuTINE.
Use this command to calibrate the radius and moment of the main boom. It requires readings from
the main boom at high and low angles fully retracted retracted, and at high and low angles extended
to predetermined lengths. All required data must be stored for the calibration to function properly.
If the data is not stored, the system will display a warning message and the calibration must be
repeated.
High angle is considered greater than sixty degrees (60°). Low angle is considered less than twenty
degrees (20°). Any attempt to acquire data outside of these limits will result in the warning message
“poor angle.” If this message is displayed because of an error, it can be corrected. The procedure
may then be continued using corrected data. If this message is displayed due to requiring data
outside the preferred angles, then the data may be entered using the high angle or low angle key to
indicate the unusual angle for which data is being acquired.
Exit any previous calibration. Press the crane setup button and select fully extended
1.
outriggers, main boom, no attachments, or a stowed attachments.
Fully retract the boom and lower (if necessary) to five degrees (5°).
2.
Determine the weight of the hook block in use. Measure the radius from the centerline of
3.
rotation to the center of the hook or line (if single part).
Raise the hook block close to the two-block weight to eliminate rope weight.
4.
Enter calibration mode (
5.
see page 4).
Press the key adjacent to either
Menu Up
or
Menu Down
to
go to “05 Radius/Mom”.
Press the key adjacent to
05 Radius/Mom
.
LOAD
0.8
ANGLE
41.8
RADIUS
76.2 FT
LENGTH
106.0
05 Radius/Mom
Menu Up
Menu Down
Exit
Summary of Contents for MG-534
