Link-Belt MG-534 Calibration
30
W450160 10/07
Menu 06 – Boom Deflection Correction
If this is not a prototype calibration, all radius/moment data should be precalibrated and copied over
for use during crane data reset. There should be no need to perform this routine.
With the boom fully extended at an angle of approximately 65°, pick up the maximum permitted load.
Refer to the data sheet for the specific crane model.
Measure the deflected radius and add 0.2 feet to the measured radius. The radius is measured from
the centerline of rotation to the center of the load. If the radius is already correct, skip this procedure.
From the previous menu, press the key adjacent to
Menu Up
to go to “06 Boom Defl’n”.
Press the key adjacent to
06 Boom Defl’n
.
Press the key adjacent to
Calibrate New F
.
Press the key adjacent to
Yes! Calibrate!
to start the
calibration, otherwise press the key adjacent to
No, Exit/
Abort
to cancel.
LOAD
0.8
ANGLE
41.8
RADIUS
76.2 FT
LENGTH
106.0
06 Boom Defl’n
Menu Up
Menu Down
Exit
LOAD
0.8
ANGLE
41.8
RADIUS
76.2 FT
LENGTH
106.0
Boom Defl’n
Calibrate New F.
CurrentF= -0.500
Ofld ang = 0.00
Onld and = -0.72
Exit
LOAD
0.8
ANGLE
41.8
RADIUS
76.2 FT
LENGTH
106.0
Boom Defl’n
YES! Calibrate!
NO, Exit / Abort
Summary of Contents for MG-534
