05.2012
42
I
II
III
IV
1.
2.
5.
3.
4.
a
Tetra
Subject to technical modifications
7.6 Insert the supports
NOTE
Before inserting the set-down
supports the folded out implement
must be folded into its transport
condition - see Chapter “Fold in
the implement“ - Page 54.
Coupling the implement
Fig. 46; Bottom supports
NOTE
The Tetra 7500 L and 9000 L
are also equipped with set-down
supports (III + iV) at the rear. These
must also be retracted as described
above before driving on the roads or
working in the fields.
Fig. 47; Slide in the support
Fig. 48; Rear support, Tetra 7500 L and 9000
L
►
Lift the implement with the three-point
power lift until the supports (I + II) are
free of the ground.
►
1.) Pull out spring cotter.
►
2.) Pull out pins.
►
3.) Slide in the support fully.
►
4.) Fasten the support by inserting the
pin above the receptacle (a).
►
5.) Secure the pin with a spring cotter.
Summary of Contents for Tetra 3001 L
