E39.0.31.6C-03
Operating instruction T-Logg 160
page 6 of 8
7. Insert the new button cell (type CR 2032) with correct
polarity in the socket (the positive pole is on the retaining
bracket).
8. Induct the sensor connection into the hole of the probe
tube and put the board into the housing.
9. Thread the foam rubber onto the connector again and
move it back into the probe tube.
10. Plug the sensor element to the connector (mind right
mounting position).
Note:
The connection pins can break if they are
inappropriately handled!
11. Screw the protective head on the sensor tube.
12. Reassemble the cover to the housing.
Finished
Environmental Reference!
Empty and defective batteries must not be disposed in the
regular domestic waste.
Return the used batteries to an authorised battery
collecting point or send the batteries directly to us
(sufficiently stamped).
