S31.0.11.6C-02
page 1 of 1
external start key for
EASY
LOG...
ESK-1
START
ESK-1
EASY
LOG
-
Startschlüssel
Control
Hinweis:
Bei schwacher LED-Anzeige
bitte 9V-Batterie ( IEC 6F22 )
wechseln
General information:
The ESK-1 is a battery driven start key for the
EASY
LOG-
series, to start
EASY
LOG
´s which are in start mode
"external start" (refer to
EASY
LOG
manual).
Specification:
Supply voltage:
9V battery
Working temperature:
0 to 50°C
Storage temperature:
-20 to 70°C
Relative humidity:
0 to 80 % r.h. (non-condensing)
Dimensions:
62 x 107 x 26.5 mm (W x H x D)
Weight:
approx. 110g (incl. batterie)
EASY
LOG-
connection:
approx 1m cable with special plug
Note:
- connect
ESK-1
with connecting cable to the
EASY
LOG
.
- press start button for 1 sec.
- the connected logger will start the recording.
- disconnet ESK-1.
Safety requirements:
This device has been designed and tested in accordance with the safety regulations for electronic devices.
However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and special
safety advises given in this manual will be adhered to when using the device.
1. Trouble-free operation and reliability of the device can only be guaranteed if the device is not subjected to any other
climatic conditions than those stated under "Specification".
2. Prior to opening it, disconnect device and supply voltage source. Make sure that all parts of the device are protected
against direct touching when mounting the device and setting its connections.
3. Please always adhere to the standard safety regulations for electric devices, power systems and light-current
installations, and make sure that your national safety regulations (e.g. VDE 0100) are observed.
4. If device is to be connected to other devices (e.g. PC) the circuitry has to be designed most carefully. Internal connection
in third party devices may result in not-permissible voltages.
5. If there is a risk whatsoever involved in running it, the device has to be switched off immediately and to be marked
accordingly to avoid re-starting.
Operator safety may be at risk if:
- there is visible damage to the device
- the device is not working as specified
- the device has been stored under unsuitable conditions for a longer time.
In case of doubt, please return device to manufacturer for repair or maintenance.