H82.0.02.6C-05
Operating Manual GMH 5150
page 14 of 22
_____________________________________________________
_____________________________________________________________________________
b) Read manual recordings:
Saved data sets can be viewed both with PC-software GSOFT3050 and directly on the device display.
Do not change the pressure sensor if manual recording is selected and values are already
stored, because otherwise invalid data may be read-out. The pressure sensor used during the
recording has to be connected!
Press “menu” for 2 seconds:
is displayed
“rEAd LoGG” is only displayed if data sets have been already stored. Otherwise the
configuration menu is displayed:
Press shortly:
Change between measuring values, measuring point and
date+time of the data set
or
Change between different data sets
End display of recordings
c) Clear manual recordings:
If data sets have been stored, they can be deleted with the “store” key:
Press for 2 seconds
: Call menu “Clear”
Select with
or
:
Clear nothing (cancel menu)
Clear all recordings
Clear the last recording
Confirm selection and quit menu “Clear”
8.2 Automatic Recording with Selectable Cycle Time
(“Func CYCL“)
If logger function “Func CYCL” is selected (p.r.t. “Configuration” ) the device will automatically record
measuring values at intervals of the set cycle time.
The logger„s cycle time can be set from 1s to 60min (p.r.t. “Configuration”).
Storable data sets: 10000
A data set contains at slow measuring rate (
rAtE SLo
):
-
measuring value
at the time of the recording
-
CALC off *):
min-peak
,
max-peak
since the last recording
-
CALC active *): Calculated value at the time of the recording and dummy value
At data set contains at fast measuring rate (
rAtE FASt
and
rAtE P.dEt
):
-
arithmetic average
since the last recording
-
CALC off *):
min-peak
,
max-peak
since the last recording
-
CALC active *): Calculated value at the time of the recording and dummy value
*) CALC-Function: see chapter 7.6, 7.7
