Mac/Pc
GETTING STARTED
USING USB/WI-FI CONNECTION
01. USING USB:
USB
Cable
NOTE: make sure the Silab USB driver is already installed. Driver can be found
at:
www.gremsy.com -> Support -> Software & Manuals.
STEPS TO CONNECT:
1 - Power on the H3.
2 - Connect USB cable from gStabi controller to Mac/PC.
3 - Run the gStabiSC software.
4 - In gStabiSC software, select “Serial” option on “connection” tab.
5 - Select the port in the list.
6 - Click on the “Connect” button.
To configure and monitor data of gStabi Software/Apps either USB/WI-FI connection is required.
Connect / Disconnect
Button
Serial Port List
11
Summary of Contents for H3
Page 1: ...GREMSY H3 USER MANUAL Ver 1 6 ...
Page 35: ...gremsy com ...