BALANCING THE H3
STEP 4: PAN BALANCE
Tilt the handle about 20 degrees and identify if the gimbal is front heavy or back heavy. Slide the pan axis slider until the camera does not swing.
NOTE:
Make sure the battery is installed before doing Pan Balance.
1.
Gently loosen the knobs on the pan axis
slider to allow the pan axis slider to slide
front or back.
4.
If the back of the gimbal is pointing to
the low side it means the gimbal is back
heavy. Slide the pan axis slider to front.
2.
Align pan axis parrallel with the handle
bar and release. Observe which way the pan
axis rotates.
5.
Try sliding the pan axis slider to the front
or back until the camera does not swing and
camera will stay at any given position when
released. Tighten both knobs to make sure
pan axis slider is locked in place.
3.
If the front of the gimbal is pointing to
the low side it means the gimbal is front
heavy. Slide the pan axis slider to back.
16
Summary of Contents for H3
Page 1: ...GREMSY H3 USER MANUAL Ver 1 6 ...
Page 35: ...gremsy com ...