Page 10
SKU 65075
For technical questions, please call 1-800-444-3353.
Place fresh, clean bearing grease in
5.
the packer.
With the grease-filled bearing packer
6.
in one hand and the bearing in the
other, press the bear ing into the
grease, forcing the grease inside the
slots in the bearing, continue doing
this until every slot in the bearing is
completely full of grease.
Hub and Wheel assembly
Put a Seal (59) and Bearing (49) on
7.
the Axle and then put the Tire (48) on
the Axle.
With each Tire in place, add a Wash-
8.
er (50) and a Spindle Nut (51) onto
the ends of the Axles. Tighten the
Spindle Nuts to 20-25 Ft.-Lbs. and
turn each tire several times to seat
the bearing. Back off the Spindle Nut
one half turn. Insert a Cotter Pin (25)
through both the Axle and the Spindle
Nut (51) and bend the end of the Pin
back to hold it in place. Last, tap on a
Wheel Cap (61).
connecting the rail assembly to the oil
tank
Insert the Front Leg Assembly (11)
9.
into the bracket on the Oil Tank As-
sembly (10B). Insert the remaining
Hex Bolt (16) through the hole in the
middle of the bracket of the Oil Tank
Assembly. Secure it with a Hex Nut
(17) and a Hex Bolt (16).
note:
When travelling, remove the Push
Pin (26) and Hair Pin Clip (29) and lift
the Front Leg Assembly up so that it
is parallel to the Rail Assembly. Re-
place the Push Pin (26) and Hair Pin
Clip (29) into the Horizontal Transport
Hole shown just above the Oil Plug.
To connect the Rail Assembly (2) to
10.
the Oil Tank Assembly, insert a Hex
Bolt (16) into the middle hole of the
“L” shaped bracket on the Oil Tank
Assembly. Secure it with a Hex Nut
(17).
In FIGURES 1 and 2 (see next page),
11.
the Rail Assembly (2) is shown in
Horizontal mode for opera tion and
travel (as mentioned above, the Front
Leg Assembly (11) must be secured
up in the horizontal position when
travelling).
operating instructions
read the entire iMportant
saFety inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
starting the engine
inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. if any
problems are found, do not use
equipment until fixed properly.
checking engine oil level
caution!
Your Warranty is VOID if the
engine’s crankcase is not properly
filled with oil before each use. Before
each use, check the oil level. Do not
run the engine with low or no engine
oil. Running the engine with no or
low engine oil WILL permanently
damage the engine.
Clean the Oil Filler Cap and the area
1.
around it.
