SKU 65076
For technical questions, please call 1-800-444-3353.
Page 7
Basic speciFications
Fuel
Type
89+ octane unleaded
gasoline
Capacity
1 Gallon
Equipment
Lubricant
Type
5W30 (above 32° F)
10W30 (at 32° F or
below)
Capacity
1.1 Quarts
Hydraulic Fluid
2.5 Gallons
Rotation
viewed from PTO
(power takeoff - the output shaft)
Counterclockwise
Maximum Log Size
25” Long x 8” Diameter
Tire Air Pressure
60 PSI (cold)
note:
Engine specifications are found in
the engine manual supplied with this
equipment.
unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
set up instructions
read the entire iMportant
saFety inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
to prevent
serious injury
FroM accidental
starting:
turn the power switch of the
equipment to its “oFF”
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
assembling or making any
adjustments to the equipment.
to prevent
serious injury:
operate only with proper
spark arrestor installed.
operation of this equipment
may create sparks that
can start fires around dry
vegetation.
a spark arrestor may be
required.
the operator should contact
local fire agencies for laws
or regulations relating to fire
prevention requirements.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
Due to the size and weight of the Log
1.
Splitter, assembly should be per-
formed with assistance.
Access the Tires (48) for the following
2.
maintenance and assembly steps.
packing the bearings.
Using a suitable solvent, clean the
3.
bearings and the rest of the parts in
the Hub assembly. The parts must be
