Configuring PowerMonic Remote Communications
page 11
8.0
Step 7: Validate Comms Module
Launch PM Sync software application. Cycle the power to PM-Comm by
disconnecting AC power lead and connecting it back to PowerMonic. Device re-
initialization will take up to 5 minutes. Select Manual Mode for PM Sync and
under the Add Device section, key in the device name and the CommsModule's
static Ethernet IP address. Note that device name is the user’s prerogative and
10.10.20.100 is the default IP address. Click ‘Test’ to make sure PM IP is
correct. Proceed to Step 8, if valid 3G SIM card is present to setup 3G remote
communication.
Figure 11: PM sync test check
