Configuring PowerMonic Remote Communications
page 7
Figure 5: PowerView comms module config
Disconnect USB cable to PowerMonic and remove the Sierra 3G modem if it
has been installed on CommsModule. Please note that the default static IP
address for the Comms Module is 10.10.20.100.
6.0
Step 5: Establish Ethernet Connection
Please note that step 5 is necessary for remote communication setup prior to
establishing the 3G connection and it only has to be performed once. Make the
physical connection between the network cable to the Comms Module PCB. To
do so, the user has to disassemble the PowerMonic top plate prior to
connecting the network cable. Instructions are as follows:
