!!
Version 01.18
8
Construction tolerances may not be
compensated via the armatures!
Sliding bi-fold shutters
Attenzione
4.6 Installation runner and guide rail
Runner rail (top)
• Check the installation situation
• Fastening holes must be drilled
• Install the runner rail on the subsurface using suitable fastening material (no horizontal deviation!)
• Two additional screws are required for the parking position
Guide rail (bottom)
• With the fixed sash removed from the package, measure the distance to the guide rail (bottom).
• Drill fastening holes in line with the runner rail and fasten with fastening material
• Mount the window shutter and check that it runs freely
4.7 Shutter packages
• Verify which one is the fixed sash; it can be recognized by its armature
• Unhinge the pre-installed fixed sash from the shutter package by loosening the hinges
• Place the fixed sash in front of the window
• Install the fixed sash in accordance with the instructions on the following pages, then install the
sashes in pairs. Sashes 2 and 3, 4 and 5, etc.
