5
IDENTIFYING YOUR CONTROLLER
The key switch modes are detailed below:
C21B/ C41B with basic On-Off key isolator
C23B/C43B with “Lock-it-Well” On-Off key
isolator
C21D-2/C41D-2 with Multi-Mode key isolator
(Off-Auto-Auto/Man)
WARNING
The OFF position on the key switch DOES NOT ISOLATE POWER. Power must be isolated at the source before accessing the control
enclosure, or working on any aspect of the door or opener.
OFF
The C10A controller will not operate
from any source.
WARNING!! THIS IS NOT POWER
ISOLATION!!
ON
Enables the use of the C10A front
panel buttons, rear panel connections
and all other inputs via EB1, radio or
toggle input
OFF
The C10A controller will not operate
from any source.
WARNING!! THIS IS NOT POWER
ISOLATION!!
AUTO Isolates the C10A front panel UP and
DOWN buttons to prevent tampering
(typical mode for car park
environments)
All other inputs remain active
(EB1, radio or Toggle)
STP and the STOP button are still
active.
OPN and CLS inputs connected to the
rear of the C10A are active.
AUTO
/ MAN
Enables the use of the C10A front
panel buttons, rear panel connections
and all other inputs via EB1, radio or
toggle input
Summary of Contents for C10A
Page 19: ...19 NOTES ...
