31
WIRELESS PROGRAMMING
REMOTE CONTROL PROGRAMMING
43
Programming of Remote Controls
1. Press and Hold the button on the hand-held transmitter or wall
button that you wish to use.
2. Press and release the "S" button on the opener.
3. Release the remote control button after 3 seconds. It has learnt the
code.
4. The screen will change to TRANSMITTER LEARNED before
changing back to the STANDBY screen.
Now the opener will operate when the transmitter button is pressed.
To Erase all Transmitter Codes
1. Press and hold the “S” button on the opener for approx. 6
seconds.
2. Release the button, all codes are now erased.
3. The screen will change to ALL TRANSMITTERS ERASED before
changing back to the STANDBY screen.
NOTE: The transmitter(s) supplied with your opener are preprogrammed by the factory. If you purchase additional
transmitters, the gate opener must be programmed to accept the new transmitter code.
Activate the opener only when the gate is in full view, free of obstruction and properly adjusted. Do not allow
children to operate push button(s) or transmitter(s). Do not allow children to play near the gate.
S
P
+
-
TRANSMITTER
LEARN MODE
PRESS S TO EXIT
Programming of Remote Controls to activate Pedestrian mode
1. Press and Hold the button on the hand-held transmitter or wall
button that you wish to use.
2. Press and release the "S" and "+" buttons simultaneously on the
opener.
3. Release the remote control button after 3 seconds. It has learnt the
code.
4. The screen will change to TRANSMITTER LEARNED before
changing back to the STANDBY screen.
S
P
+
-
TRANSMITTER
LEARN MODE (PED)
PRESS S TO EXIT
