Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.Griffin-Stands.com/Videos
Step 8
–
Now take Back Panel (Part E) and place it on the
back of the stand. This is secured by a Velcro (See
Figure
13
). And do the same thing for Front Panel (Part F). For
the Front Panel (Part F), make sure that the ribbon is
flipped outside so that removing the front panel is easy.
Step 9
–
Figure 14
shows how to lock and unlock the top
lid. The top lid can be removed if you tilt it all the way to
the back. It can be removed from the hinges by design.
Step 10 -
For safety reasons, please always make sure to
test the stability and safety of the product before use.
Double check all nuts and bolts, knobs and connectors,
make sure that these are tight and securely fastened
before use of your product. Test the product under light
use or light loads the first time to confirm assembly and
structure of the product is correct.
Your rack case has many great features. Let’s talk about
a couple. To use the locking latch, simply turn the knob
on the bottom half of the latch counter clockwise until
the latch is fully extended. Then push the latch forward
until the latch goes into the slot on the upper half of the
latch found on the lid. Then turn the knob clockwise to
hold it in place. It even comes with a place you can put a
lock on your case. The front panel and back panel can be
removed for easy access to your equipment. The back
panel even has a hole for running your cables through
for a nicer and neater looking setup.
Please note that if your mixer is smaller than the minimum
capacity of the top shelf, you will need a wider rack ears to
be able to mount your mixer. Place heavy equipment at
the bottom and lighter equipment at the top. See
Figure
15
for how a mixer should look like installed.
Two of your casters have locking wheels. To use the locks,
simply push down on the “brake” that sticks out from the
wheel. To release the “brake” just pull up on it. This is a
great feature that you’ll be using often. Your DEQ
-02
comes with pre-installed rack mount brackets and the
screws to install your equipment. Use the included screws
to attach the “wings” of your rack mount equipment to the
rack rails. The top will hold a “flat” or “slider” sound board.
