GRILLA PELLET SMOKER GRILL
OPERATION MANUAL
8
Ignition Sequence
When Power button is pressed:
Shutdown Sequence
When Power button is pressed:
ErL (low temp) Code
RrH (high temp) Code
FHi (food high) Code
Power Button
Temperature Setting Buttons
Probe Button
CONTROLLER OPERATION
• Starts “Ignition” Sequence
• Starts “Shutdown” Sequence
• Resets Error codes
• Igniter
turns on and runs for 4 minutes. At 4
minutes if temp is 150°F, it turns off. If temp is
below 150°F after 4 minutes, it stays on for 4
more minutes (8 total) then turns off.
• Auger
turns on at 100% for 4 minutes then goes
to normal temperature control operation.
• Fan
runs continuously.
• Board
displays current temperature. If below 110°F
(likely at startup) the display will be flashing until
above 110°F. It has 10 minutes (ERL requirement) to
get above this or it initiates ERL code.
• Auger
turns off.
• Fan
continues to run for 5 minutes.
• Board
displays C5, C4, C3, C2, C1 (minutes)
then goes blank.
• Grill temp was below 110°F for more than 10 minutes.
• Grill temp reached 615°F.
• Food probe is above 225°F. Removing probe from socket returns board to normal readout.
• Moves temperature setting up or down in 5-degree increments from 180 to 500°F. Holding for 2 seconds
will change temperature quickly. Default 350°F.
• When grill is on, pressing button will change readout to show the meat probe reading. This reading will
display for 5 seconds. Then it will return to show the current grill temperature.
