6. Turn the coupling nut clockwise and tighten to a full
stop. The regulator will seal on the back-check feature
in the LP tank valve, resulting in some resistance.
An
addi onal one-half to three-quarters turn is required to
complete the connec on. Tighten by hand only-do not
use tools.
NOTE:
If you can complete the connection, disconnect
regulator and repeat steps 5 and 6. If you are still
unable to complete the connection, do not use this
regulator!
Hold coupling nut and
regulator as shown for proper
connection to LP tank valve.
WARNING
DANGER
•
Do not insert any tool or foreign objects into the
valve outlet or safety relief valve. You may
damage the valve and cause a leak. Leaking
propane may result in explosion, fire, severe
personal injury, or death.
•
If a leak is detected at any time, STOP and call
the fire department.
•
If you cannot stop a gas leak, immediately close
LP tank valve and call LP gas supplier or your
fire department!
•
Never attempt to attach this grill to the
self-contained LP gas system of a camper trailer
or motor home.
•
Do not use grill until leak-tested.
Leak Testing Valves, Hose and Regulator
1. Turn all griddle control knobs to OFF.
2. Be sure regulator is tightly connected to LP tank.
3. Completely open LP tank valve by turning OPD
hand wheel counterclockwise. If you hear a
rushing sound, turn gas off immediately. There
is a major leak at the connection.
4. Brush soapy solution onto areas where bubbles
are shown in picture below.
5. If “growing”
bubbles appear, there is a leak. Close
LP tank valve immediately and retighten
connections.
If leaks cannot be stopped do
not try to repair.
6. Always close LP tank valve after performing leak
test by turning hand wheel clockwise.
6
