Manual CC2 © Grimm Audio
7
distance between monitors (LCD and CRT) and audio
cables because of risk of induced low level noise due to
stray magnetic fields.
Grimm Audio products have a real wooden face plate
that provides a beautiful and vivid appearance. The CC2
front panel is made of Padouk. The panel is finished
with an environmentally friendly oil. To maintain the
outstanding looks, one is advised to take some
precautions:
•
Do not place the CC2 in very dry environments.
•
Do not use chemical or alcohol based cleaner on
the wood.
•
Avoid exposure to direct sun light, since the padouk
wood is susceptible to discolor in UV light.
AC Power Hookup
The CC2 has a linear power supply that needs to be
factory set for your local line voltage (115V or 230V +/-
10%). Make sure to check the line voltage at the back
near the IEC cable entrance (‘wired for ... V’) and verify if
this complies with your local mains voltage. The CC2 is
shipped with a proper mains cable. Grimm Audio
cannot be held responsible for problems caused by
using the CC2 with improper AC wiring or voltage.
The CC2 does not have a power switch on the front
panel; a convenient way to power down the unit is to
use a power strip equipped with a switch or eventually
power it down with the mains switch at the back.
3.
In
sta
llin
g
