GMAC Installation Guide
Rev 1.0
Tools needed:
Adjustable Wrench (10mm-17mm) - T20 torx screwdriver - M4 Allen Key
Machined Torque Arm Components:
Torque Plate Installation:
•
If the motor requires a disk rotor, remove the installed torque plate to
access disk rotor bolts. This may require prying with a screwdriver.
•
Remove the disk spacer ring and replace it with the disk rotor.
•
Reposition the torque plate over the axle splines, aligning the slot with
the wire exit.
•
Align the splines of the axle into the torque plate and press or tap the
plate down until the splines protrude past the plate.
