6
American Metal Ware
PB330 & PB430 Shuttle
®
Brewers
Adjustments (cont.)
Temperature Adjustment (continued)
Brew Volume “br”
Brew time can be set for each size visually. See
Setting Brew Volume
Procedure below.
Brew time can also be adjusted through the display. See
Programming
section.
Setting Brew Volume Visually
1. Remove brew basket and place container under brew head.
2. Press and hold desired brew button for 5 seconds. Display will read “Pro”.
3. Within 20 seconds, press and release desired brew button. Water will dispense from spray head and time will
count-up in display.
4. When volume is at desired amount, press and release brew button to stop flow. Time will flash in display.
5. Within 20 seconds, press and release desired brew button. Display will clear and brew time will be stored into
memory.
Note:
During this routine, no pulsing or bypass will occur.
Note:
If the On/Off button is pressed during procedure, time setting will default to previous time.
WARNING: ELECTRIC SHOCK HAZARD!
Dangerous electric voltages are present near adjustable
components. All adjustments should be performed by qualified service personnel only.
Control Features
Pre-infusion:
Controls the initial coffee grounds wetting and the first dwell time after the initial wetting. Pulse
brews are the series of pulses after the Pre-infusion process. All pulse ON and OFF times are the same.
Brew Countdown Timer:
After the start of a brew the LED display will countdown the remaining time left in
the brew process. The countdown will include all OFF periods programmed in the Pre-infusion and the pulses. At
the end of the brew time, the display will scroll driP, while the brew basket drains itself. At the end of the drip
cycle, the display will scroll donE for 30 seconds then turn off.
Energy Savings Mode:
If enabled, when the brewer is idle for three (3) hours this feature will allow the water
tank to lower its holding temperature to 120°F. The display will scroll SLEEPIng while in this mode. To exit energy
savings mode press any button and the unit will start reheating to brewing temperature.
Copy-to-Left:
On twin brewers, this feature allows you to copy the brew parameters programmed on a particular
brew portion on the Right side to the Left side.
