Adjustments (cont.)
Drink Strength Adjustment (Refer to Figure A & B)
Tools required: #2 Phillips Screwdriver
1. Dispense a drink to determine if drink is too strong or weak.
2. Turn off power to machine at power switch.
3. Remove front splash panel below dispense heads in front of machine.
4. Locate the mix ratio setting panel directly behind the front splash panel (see Figure B)
5. Adjust drink strength by determining the digital setting for the desired mix ratio. (Note: Clockwise will strengthen
product, counterclockwise will weaken the product.)
Note: (For Hot Chocolate see figure B and follow the same steps as above.)
Service and Cleaning
Daily Cleaning Instructions for the LCD Coffee Dispensers:
1. Wipe down all stainless steel surfaces of the dispense spout, bag-in-box cabinetry and drip tray areas with a clean
soft cloth using a mixture of one oz. (28 g) Ivory liquid detergent or equivalent to one gallon (3.8 litre) of fresh water.
2. Follow by wiping down all stainless steel surfaces of the dispense spout and cabinetry with a clean soft cloth
moistened with fresh water and allow to air dry.
3. Remove drain tray and wash in a three compartment sink with warm soapy water per above concentration until all
signs of product residue are removed, rinse thoroughly with fresh water and air dry.
Weekly Cleaning Instructions for the LCD Coffee Dispensers:
1. Flip water switch (a) to “OFF” position.
2. Remove fitting cap (a) from bag-in-box quick disconnect fitting then remove internal check valve parts by rotating the
retaining cap at the opposite end of the o-ring end. This will allow free flow of sanitizing solution through the
connector and faster cleaning.
2a. For Hot Chocolate disconnect BIB fitting and insert Scholle probe sanitizing attachment (not provided).
3. Insert the bag-in-box quick disconnect fitting into a one gallon (3.8 litre) basin of very warm (150°F/65.56°C) soapy
water. Use 1/2 oz. (14 g) Ivory liquid detergent or equivalent to one gallon (3.8 litre) of water.
4. Push and hold the corresponding dispense switch until clear soapy water is dispensed from the spout.
American Metal Ware Liquid Coffee Dispenser
Page 6
Figure B
WARNING: ELECTRIC SHOCK HAZARD
Always disconnect power to the machine before servicing or cleaning. Risk of electric
shock is present which can cause serious injury or death.
!
Summary of Contents for American Metal Ware LCD2-1
