3
PRIOR TO TOOL OPERATION
The tool is intended to be operated as a hand held tool. It is always recommended
that while using the tool, operators stand on a solid floor, in a secure position with a
firm grip and footing.
Caution:
Use a constant, clean air supply that will give a measured air pressure
at the tool of 58 to 115 psi when the tool is running with the lever fully
depressed. It is recommended to use an approved 3/8” (10mm) hose
with a 50' (15.24m) maximum length.
Note:
Constant air rates vary depending on size and power of the air compressor.
USAGE
Your Griot’s Garage Air Pulse Blow Gun has a detachable brush set. The Air Pulse
Blow Gun may be operated with our without the brush attachment installed.
To remove brush attachment, gently apply slight outward pressure to the retainer
levers on the cone nozzle. To install, align pins on brush set with retainer levers and
apply light pressure until brush seats into cone nozzle.
The Air Pulse Blow Gun comes equipped with an Air Pulse Firm Brush attachment.
Air Pulse Firm Brush - Item # 90554
Perfect for intense cleaning action addressing dirt and grime on vinyl, carpet,
upholstery, door panels. Our recommended brush for cleaning Microfiber and Foam
Buffing Pads during use.
MAINTENANCE
a) Following use, submerse cleaning brush set and nozzle into clean water, pull
trigger and run for 20 seconds.
b) Replace damaged parts immediately. The rotate-set, nozzle, hoses, and gaskets
are consumable parts.
