5
4
SAFETY
SAFETY
SAFETY INSTRUCTIONS
WEAR SAFETY GLASSES
Always wear safety glasses with side shields that meet ANSI
Z87.1 requirements when operating the tool. Make sure all
others in work area wear safety glasses.
WEAR HEARING PROTECTION
Wear hearing protection to protect your hearing from noise.
Prolonged exposure to loud noise can result in hearing loss.
NEVER OPERATE THE TOOL WITH OXYGEN OR OTHER
BOTTLED GASES
Oxygen and other reactive or high-pressure bottled gases
can cause the tool to explode. Use clean, dry regulated
compressed air from a properly operating air compressor.
DO NOT EXCEED MAXIMUM RECOMMENDED OPERATING AIR
PRESSURE OF 110 PSI /7.6 Bar.
Exceeding the maximum recommended air pressure can
cause the tool housing to burst, or cause premature failure of
components.
NEVER CONNECT THE TOOL TO AN AIR SUPPLY THAT HAS
THE POTENTIAL TO EXCEED 180 PSI/12.4 Bar.
Using a regulated air supply with a line or tank pressure
greater than 180 psi can cause the tool to burst if the air line
regulator fails suddenly.
USE AN AIR HOSE RATED FOR 180 PSI/12.4 Bar OR
GREATER
Always use air hose rated to handle 180 psi or the maximum
potential pressure of the air supply.
DO NOT ATTEMPT TO OPERATE THE TOOL IF THE TOOL’S
OPERATING CONTROLS HAVE BEEN MODIFIED OR ARE NOT
WORKING PROPERLY.
Attempting to use a tool with modified or malfunctioning
trigger or workpiece contact can result in a fastener being
driven unintentionally.
USE CORRECT FASTENERS
Only use the correct fastener for the tool. Using fasteners
with incorrect specifications can jam the tool or cause
serious injuries.
110 psi
4 bar
60 psi
7.6 bar
USE THE CORRECT FASTENERS FOR THE APPLICATION.
Using the wrong fasteners can cause the workpiece to split and allow the
fastener to fly free.
DO NOT DEPRESS TOOL NOSE WHEN LOADING FASTENERS
Depressing the tool nose during loading can result in tool actuation and an
unintentional fastener drive
AVOID DRIVING FASTENERS INTO KNOTS, ON TOP OF OTHER FASTENERS, AT
WORKPIECE EDGES, OR INTO BRITTLE MATERIALS.
Driving fasteners into extremely hard materials, or driving into workpiece
edges, can cause fasteners to deflect away from the workpiece. Flying
fasteners can cause serious injuries.
KEEP HANDS AND BODY PARTS AWAY FROM AREA BEING FASTENED.
Fasteners can deflect and turn as they are being driven into the workpiece, and
penetrate fingers, hands, and other body parts that may be in the fastening
area.
DO NOT OVERREACH OR WORK WHILE ON UNSTABLE FOOTING
If you lose your balance while fastening, you could drive a fastener into yourself
or a bystander.
DO NOT USE TOOL IF TOOL MALFUNCTIONS OR BEGINS LEAKING AIR.
Operating a malfunctioning tool can result in an injury to yourself or others.
DISCONNECT THE TOOL FROM THE AIR SUPPLY TO PERFORM MAINTE-
NANCE.
Never attempt to reload a tool, clear a jam, or perform maintenance without
first disconnecting the air supply.
NEVER LEAVE A PRESSURIZED TOOL
UNATTENDED
A pressurized tool could be picked up or handled by someone who is unfamil-
iar with the tool or that has not read the tool manual.
KEEP TOOLS OUT OF THE REACH OF CHILDREN
Place the tool back in the tool box after use, and store the tool out of reach.
DO NOT MODIFY TOOL
Modifications can cause a tool to be unsafe and can cause the tool to operate
improperly.
SAFETY INSTRUCTIONS
